A good storage cover is
essential to protect your Yamaha watercraft while it is stored.
Our cover is made of 600D solution dyed polyester, which
means the color goes all the way through and is much more fade resistant that
other covers. Each Yamaha Jet Ski cover comes with a tie down strap kit for
The Yamaha covers work great for indoor and outdoor storage
applications and the 600D material is breathable to help prevent mildew growth
and allow moisture to evaporate.
All Yamaha covers come in a Black and Gray 2 tone color
Yamaha covers have a 1 year warranty against defects in
workmanship or material.
ApplicationsYamaha FZS 2009-2016
WarrantyWatercraft Superstore covers have a 1 year manufacturer's warranty against defect in material and workmanship. This warranty does not cover fading, tearing or stains which are likely during normal use. Environments with extreme weather conditions might have an adverse effect on the longevity of the material which will not be covered under warranty.
If you should have a problem, please contact SBT @877.330.0321 or email@example.com
InstallationYour new Watercraft Superstore cover is designed to give years of protection to your PWC. To install the cover, it is best to start at the handle bars and mirrors (if equipped) then pull the cover forward over the bow and rearward over the stern of the craft.
The shock cord installed at the hem of the cover should be pulled down under the rub rail of the PWC. Most covers will hold in place with just the use of the shock cord for stationary storage.
If the craft is going to be towed or is stored in an area that gets high winds, we suggest using the provided tie down straps to wrap under the PWC to secure the cover. The watercraft should always be clean before installing any cover to prevent damage to the finish.
CleaningCleaning and Maintenance of the cover should be done periodically to help extend the life of the cover. To clean the cover, we suggest a mild liquid soap similar to soap used to wash the PWC. For bird droppings or other hard to clean spots, it may be necessary to use a scrub brush. You can rinse the cover with a standard garden hose. We do not suggest using a pressure washer since the pressure could be high enough to damage the material. If the cover is used outdoors, we suggest re-treating the cover with a water repellant treatment such as 303 High Tech Fabric Guard (available at Watercraft Superstore or other marine supply stores) at least once a year to help with water repellency as well as UV protection.
Hours of Operation EST Phone Orders:
Monday-Thursday : 8am-5pm
Friday: 8am-12pm Walk-In:
Showroom is closed until further notice.
Short Block Technologies
1401 N Myrtle Ave
Clearwater, FL 33755